Sea-Bird Electronics SBE 38 Bedienungsanleitung PDF herunterladen (Seite 96)

Manual revision 006 Section 5: Routine Maintenance and Calibration SBE 19plus V2

4. Reinstall the battery pack in the housing:

A. Align the battery pack with the housing. The posts inside the housing

are not placed symmetrically, so the battery pack fits into the housing

only one way. Looking at the bottom of the battery pack, note that

one tube is closer to the edge than the others, corresponding to the

post that is closest to the housing.

B. Reinstall the three cap screws until they are snug against the top plate.

While pushing hard on the protective plastic plate to depress the

spring contacts at the bottom of the compartment, continue to tighten

the cap screws. Repeat until all three cap screws are tightened and the

battery pack cannot be pushed further into the housing. The screws

must be fully tightened, or battery power to the circuitry will

be intermittent.

5. Reinstall the battery end cap:

A. Remove any water from the O-rings and mating surfaces with a lint-

free cloth or tissue. Inspect the O-rings and mating surfaces for dirt,

nicks, and cuts. Clean or replace as necessary. Apply a light coat

of O-ring lubricant (Parker Super O Lube) to O-rings and

mating surfaces.

B. Carefully fit the end cap into the housing and rethread the end cap

into place. Use a wrench on the white plastic bar to ensure the

end cap is tightly secured.

Verify that the magnetic switch is Off, so the SBE 19plus V2 will be in

quiescent (sleep) state.

Note:

The NiMH battery pack fits tightly in

the housing. When placing a battery

pack in the housing, align it carefully

and slowly insert it straight into the

housing. If not careful, the battery pack

shrink wrap can be torn.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 123 124

Keine Kommentare

Sea-Bird Electronics SBE 38 Bedienungsanleitung Seite 96