Sea-Bird Electronics SBE 38 Bedienungsanleitung PDF herunterladen (Seite 24)

Manual revision 006 Section 3: Power and Communications Test SBE 19plus V2

Section 3:

Power and Communications Test

This section describes software installation and the pre-check procedure for

preparing the SBE 19plus V2 for deployment. The power and communications

test will verify that the system works, prior to deployment.

Software Installation

Sea-Bird recommends the following minimum system requirements for

installing the software: Windows 2000 or later, 500 MHz processor,

256 MB RAM, and 90 MB free disk space for installation. Although

SEASOFT V2 was designed to work with a PC running Win 2000/XP;

extensive testing has not shown any compatibility problems when using the

software with a PC running Windows Vista.

If not already installed, install Sea-Bird software programs on your computer

using the supplied software CD:

1. Insert the CD in your CD drive.

2. Install software: Double click on SeasoftV2_date.exe (date is the date that

version of the software was created). Follow the dialog box directions to

install the software. The installation program allows you to install the

desired components. Install all the components, or just install Deployment

Endurance Calculator (battery endurance calculator for Moored mode),

SeatermV2 (terminal program launcher for 19plus V2), Seasave V7

(real-time data acquisition), SBE Data Processing (data processing), and

SEATERM (terminal program for setting up SBE 38 auxiliary sensor, if

applicable to your system).

The default location for the software is c:\Program Files\Sea-Bird. Within that

folder is a sub-directory for each program.

Test Setup

1. Remove the dummy plug from the Y-cable and install the I/O cable:

A. Pulling the plug firmly away from the connector, remove the dummy

plug from the 4-pin connector on the Y-cable strapped to the 19plus

V2 housing. Note that the Y-cable is connected to the Data I/O,

Pump, and External Power connector on the 19plus V2 end cap, and

provides power to the pump via the 2-pin connector as well as

communications with the computer via the 4-pin connector.

B. Standard Connector - Install the I/O cable connector, aligning the

raised bump on the side of the connector with the large pin

(pin 1 - ground) on the Y-cable. OR

MCBH Connector - Install the I/O cable connector, aligning

the pins.

2. Connect the I/O cable connector to your computer’s serial port.

Notes:

• Help files provide detailed

information on the software.

Separate software manuals on the

CD-ROM contain detailed

information on Seasave V7 and SBE

Data Processing.

• Sea-Bird also supplies an older

version of Seasave, Seasave-

Win32. However, Seasave-Win32 is

not compatible with the 19plus V2.

• It is possible to use the 19plus V2

without the SeatermV2 terminal

program by sending direct

commands from a dumb terminal or

terminal emulator, such as Windows

HyperTerminal.

• Sea-Bird supplies the current

version of our software when you

purchase an instrument. As software

revisions occur, we post the revised

software on our FTP site. See our

website (www.seabird.com) for the

latest software version number, a

description of the software changes,

and instructions for downloading the

software from the FTP site.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 123 124

Kommentare zu diesen Handbüchern

Keine Kommentare

Sea-Bird Electronics SBE 38 Bedienungsanleitung Seite 24

Kommentare zu diesen Handbüchern