Sea-Bird Electronics SBE 38 Bedienungsanleitung PDF herunterladen (Seite 87)

Manual revision 006 Section 4: Deploying and Operating SBE 19plus V2 SBE 19plus V2

7. Click the Header Form tab to customize the header:

The entries are free form, 0 to 12 lines long. This dialog box establishes:

• the header prompts that appear for the user to fill in when uploading

data, if Prompt for header information was selected

• the header included with the uploaded data, if Include default header

form in upload file was selected

Enter the desired header/header prompts.

8. Click Start; the Status bar at the bottom of the window displays the

upload progress:

A. Seaterm232 sends GetHD (get hardware data), GetSD (get status

data), GetCD (get configuration data), GetCC (get calibration

coefficients), and GetEC (get event counter), and writes the

responses to the upload file. These commands provide information

regarding the number of samples in memory, mode, header/cast

numbers, calibration coefficients, etc.

B. If you selected Prompt for header information in the Upload Data

dialog box – a dialog box with the header form appears. Enter the

desired header information, and click OK. Seaterm232 writes the

header information to the upload file.

C. Seaterm232 sends the data upload command, based on your selection

of upload range in the Upload Data dialog box, writes the data to the

upload .xml file, and then creates the .hex file from the .xml file. The

.hex file contains the data in raw hexadecimal, for compatibility with

Seasave and SBE Data Processing.

D. If you selected All data separated by cast or By cast number range

in the Upload Data dialog box – Seaterm232 repeats Steps B and C

for each cast.

E. When the data has been uploaded, Seaterm232 shows the S> prompt

(if OutputExecutedTag=N).

Defines header information

included with uploaded data:

• Prompt for header information –

Each time data is uploaded,

user is prompted to fill out user-

defined header form.

• Include default header form in

upload file – User-defined

default header form included in

upload file. User is not

prompted to add any

information when data is

uploaded.

• Don’t include default header

form in upload file – Header

information not included in

upload file.

Note:

The commands and responses

automatically sent by Seaterm232

during the upload do not appear in the

Command/Data Echo Area.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 123 124

Kommentare zu diesen Handbüchern

Keine Kommentare

Sea-Bird Electronics SBE 38 Bedienungsanleitung Seite 87

Kommentare zu diesen Handbüchern