Sea-Bird Electronics SBE 38 Bedienungsanleitung PDF herunterladen (Seite 27)

Manual revision 006 Section 3: Power and Communications Test SBE 19plus V2

3. If this is the first time Seaterm232 is being used, the Serial Port

Configuration dialog box displays:

Make the desired selections, and click OK.

4. Seaterm232 tries to automatically connect to the 19plus V2. As it

connects, it sends GetHD and displays the response, which provides

factory-set data such as instrument type, serial number, and firmware

version. Seaterm232 also fills the Send Commands window with

the correct list of commands for your 19plus V2.

If there is no communication:

A. In the Communications menu, select Configure. The Serial Port

Configuration dialog box appears. Select the Comm port and baud

rate for communication, and click OK. Note that the factory-set baud

rate is documented on the Configuration Sheet.

B. In the Communications menu, select Connect (if Connect is grayed

out, select Disconnect and reconnect). Seaterm232 will attempt to

connect at the baud specified in Step A, but if unsuccessful will then

cycle through all other available baud rates.

C. If there is still no communication, check cabling between the

computer and 19plus V2, and try to connect again.

D. If there is still no communication, repeat Step A with a different

comm port, and try to connect again.

After Seaterm232 displays the GetHD response, it provides an S> prompt

to indicate it is ready for the next command.

Note:

If OutputExecutedTag=Y, the 19plus

V2 does not provide an S> prompt

after the <Executed/> tag at the

end of a command response.

Note:

Seaterm232’s baud rate must be the

same as the 19plus V2 baud rate (set

with BaudRate=). Baud is factory-set

to 9600, but can be changed by the

user (see Command Descriptions in

Section 4: Deploying and

Operating SBE 19plus V2). Other

communication parameters –

8 data bits, 1 stop bit, and no parity –

cannot be changed.

Computer COM port and baud

rate for communication between

computer and 19plus V2.

Seaterm232 tries to connect at

this baud rate, but if

unsuccessful will cycle through

all available baud rates.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 123 124

Kommentare zu diesen Handbüchern

Keine Kommentare

Sea-Bird Electronics SBE 38 Bedienungsanleitung Seite 27

Kommentare zu diesen Handbüchern