Sea-Bird Electronics SBE 38 Bedienungsanleitung PDF herunterladen (Seite 51)

Manual revision 006 Section 4: Deploying and Operating SBE 19plus V2 SBE 19plus V2

RS-232 Sensor Setup Commands

The SBE 19plus V2 can interface with one of the following RS-232

instruments (connected to the 4-pin Auxiliary RS-232 Input bulkhead

connector on the 19plus V2 end cap):

• SBE 38 secondary temperature sensor

• WET Labs single, dual, or triple channel ECO sensor; WETStar; or C-Star

• Pro-Oceanus Gas Tension Devices (up to two GTDs can be integrated)

• Aanderaa Oxygen Optode 4330 or 4835

Setup for SBE 38:

Set up SBE 38 to interface with SBE 19plus V2, before you connect it to

19plus V2. Connect SBE 38 directly to computer, power with an external

power supply, and (using SEATERM or Seaterm232) set:

• Baud rate to same baud rate as 19plus V2 (Baud=)

• Interface to RS-232 (Interface=232)

• Sampling to begin when power applied (AutoRun=Y)

• Output to converted data (Format=C)

Connect SBE 38 to SBE 19plus V2 Auxiliary RS-232 Input connector, using

provided cable. In the 19plus V2, set SBE38=Y to enable interface.

SBE38=x x=Y: Enable RS-232 SBE 38 secondary

temperature sensor.

x=N: Do not enable SBE 38.

Notes:

• The 19plus V2 requires verification

when SBE38=, WetLabs=, GTD=,

DualGTD=, or Optode= is sent. The

19plus V2 responds:

this command will change the

scan length and/or initialize

logging. Repeat the command to

verify.

Type the command again and press

the Enter key to proceed. The

19plus V2 responds:

Scan length has changed,

initializing logging

• The 19plus V2 configuration

(.xmlcon or .con) file must match this

selection of RS-232 sensor when

viewing real-time data or processing

uploaded data. View and edit the

configuration file in Seasave or SBE

Data Processing. These parameters

are factory-set to match the ordered

instrument configuration.

• You can use Seaterm232 to

communicate directly with the

SBE 38 (when the sensor is

connected directly to the computer).

Alternatively, use the older

SEATERM software, as documented

in the manual for the SBE 38.

•

See the appropriate sensor manual

for command details for the RS-232

instruments.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 123 124

Kommentare zu diesen Handbüchern

Keine Kommentare

Sea-Bird Electronics SBE 38 Bedienungsanleitung Seite 51

Kommentare zu diesen Handbüchern