Sea-Bird Electronics SBE 38 Bedienungsanleitung Seite 39

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 124
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 38
Manual revision 006 Section 4: Deploying and Operating SBE 19plus V2 SBE 19plus V2
39
Status Commands
GetCD Get and display configuration data, which
includes all parameters related to setup of
19plus V2, including communication settings
and sampling settings. Most of these
parameters can be user-input/modified. List
below includes, where applicable, command
used to modify parameter:
Device type, Serial number
Profiling mode [MP]:
- Number of scans to average [NAvg=]
- Minimum conductivity frequency for pump
turn-on [MinCondFreq=]
- Pump turn-on delay [PumpDelay=]
- Begin logging automatically when external
power applied [AutoRun=]?
- Ignore magnetic switch position for
starting/stopping logging [IgnoreSwitch=]?
Moored mode [MM]:
- Sample interval [SampleInterval=]
- Number of measurements to take and average
per sample [NCycles=]
- Pump turn-on parameter
[MooredPumpMode=]
- Pump turn-on delay [DelayBeforeSampling=]
- Transmit data real-time?
[MooredTxRealTime=]
Battery type [BatteryType=] and cut-off voltage
Sample external voltages 0, 1, 2, 3, 4, and 5?
[Volt0= through Volt5=]
Sample SBE 38 secondary temperature sensor
[SBE38=]
Sample WET Labs RS-232 sensor [WetLabs=]?
Sample Optode [Optode=]?
Sample Gas Tension Device [GTD=], or
dual Gas Tension Devices [DualGTD=]?
Enable echoing? [Echo=]
Output Executing and Executed tags?
[OutputExecutedTag=]
Output format [OutputFormat=]
Output salinity? [OutputSal=]
(only appears if output format =
converted decimal or converted XML UVIC)
Output sound velocity? [OutputSV=]
(only appears if output format =
converted decimal or converted XML UVIC)
Output sigma-t, voltage, and current with each
sample? [OutputUCSD=]
(only appears if output format =
converted decimal or converted XML UVIC)
Notes:
GetCD output does not include
calibration coefficients. To display
calibration coefficients, use the
GetCC command.
The DS response contains similar
information as the combined
responses from GetSD and GetCD,
but in a different format.
Seitenansicht 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 123 124

Kommentare zu diesen Handbüchern

Keine Kommentare