Sea-Bird Electronics SBE 38 Bedienungsanleitung PDF herunterladen (Seite 66)

Manual revision 006 Section 4: Deploying and Operating SBE 19plus V2 SBE 19plus V2

Data Output Formats

The SBE 19plus V2 stores data in a compact machine code. Data is converted

and output in the user-selected format without affecting data in memory.

Because memory data remains intact until deliberately overwritten, you can

upload in one format, then choose another format and upload again.

Output format is dependent on OutputFormat= (0, 1, 2, 3, 4, or 5) and on the

command used to retrieve the data, as detailed below. The inclusion of some

data is dependent on the system configuration - if the system does not include

the specified sensor, the corresponding data is not included in the output data

stream, shortening the data string. RS-232 sensors always output data in the

same format, regardless of OutputFormat=:

• SBE 38, GTD, and Optode data is always output in engineering units.

• WET Labs RS-232 sensor data is always output in raw counts.

If in Moored mode and outputting real-time data (MooredTxRealTime=Y)

while logging, a # sign precedes the real-time output for each sample.

Note:

Moored mode - For date and time

output, time is the time at the start of

the sample, after:

• a small amount of time

(1 to 2 seconds) for the 19plus V2 to

wake up and prepare to sample, and

• any programmed

DelayBeforeSampling=.

For example, if the 19plus V2 is

programmed to wake up and

sample at 12:00:00, and

DelayBeforeSampling=20, the output

time for the first sample will be

12:00:21 or 12:00:22.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 123 124

Keine Kommentare

Sea-Bird Electronics SBE 38 Bedienungsanleitung Seite 66